
Lay out, center and dig all four post holes 12”
diameter x 36” deep. Posts can be no more
than 78” inside to inside.
*Note: For concrete mount installation skip to step 3.
78”
78”
1
*Note: If not using the optional concrete mounts,
skip to step 6.
36”
Install (4) 4x4x96” wood post (not
included)and level. Set your post, fill with
concrete leaving 3” from the top of the hole.
2
Place wedge anchors (R) into each hole and tap
into concrete leaving 1” above the concrete. Place
concrete post mount (Q) over the installed
anchors and install washer and nut to each
anchor. Level and tighten with 9/16” socket.
Do not over tighten.
Optional Concrete Mount Step
4
Place, square and trace each concrete post
mount. (Q) Pre-drill concrete mount holes with
hammer drill at 4 1/2” depth with 3/8”
masonary bit.
Do not rush.
Optional Concrete Mount Step
3
Comentarios a estos manuales