Weatherables PWPI-THD3-4x8DE Guía de instalación descargar pdf (Pagina 8)

GATE INSTALLATION INSTRUCTIONS

The following is based on an assembled gate that is properly sized for opening.

SINGLE GATE INSTRUCTIONS

Determinethedirectionthegateistoswing,usuallyswingsintoyard.Besuretocheckyourlocalcodes!

Ifyouhavealuminumpostinserts,installpriortotheinstallationofthegate.Ifyoudonothaveinsertsyoumustfillthehingepostwithconcreteandrebar

afterthegateinstallation.

Locateandfollowhardwareinstallationinstructions.

The gate will be mounted to be flush with the

side of the fence that the gate will be

swinging. See the illustration to the right. Be

sure the gate will be high enough to clear

obstructions such as snow. The gate posts

should be cut on site as needed. Some

installers cut the gate posts off at the bottom

of the bottom gate pocket. DO NOT cut into

the gate pocket.

DOUBLE GATE INSTRUCTIONS

Typical gate installation based on an assembled gate that has been properly sized for the opening

A. Followthesameinstructionsasperasinglegatewheninstallingthehingesforbothgates.

B. Tocalculatethevariancesforthelatchyoumusttreatthefixedgateasifitwereastandardfencepanel.

C. Theidealhardwareinstallationonadoublegateshouldhaveequalspacingbetween

postsandgates.

D. InstalltheDropRodtopostofthefixedgate.

HIGH WIND INSTALLATION INSTRUCTIONS

FOR PRIVACY PANELS

All of our vinyl privacy panels ( up to 6' in height ) have been tested and certified to achieve high wind loads. In order to meet the wind rating

requirements, the panels must be installed as noted below. These steps are the same steps used for the certification and must be

followed exactly the same as used in testing. We tested the full privacy panels as the lowest common denominator.

ALL PRIVACY PANELS

After the fence is installed, all posts are to be filled with "Quickrete" brand of concrete to at least 22" above the ground ( inside the post ) as shown

in the following figure 1 drawings. Next, install the screws on the back side of the panel ( the side you will not see ) using #10 x 1" self-tapping

stainless steel or galvanized pan head screws which can be purchased from your local hardware store. Be careful not to overtighten or strip

Page 8 of 10

1 2 3 4 5 6 7 8 9 10

Comentarios a estos manuales

Sin comentarios

Weatherables PWPI-THD3-4x8DE Guía de instalación Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para No Weatherables PWPI-THD3-4x8DE